Jenn-Air Service Manual page 76

Panel Installation for Dispenser Models:
See section "Installing Backer Panels" for handle / trim piece
removal. With handle / trim piece removed slide upper and lower
panels in postion. To replace dispenser panels, slide out Spill Tray
grille and remove 2 Torx screws (see inset). Insert replacement
panel. Reinsert Torx screw and reinstall handle / trim piece.
To replace second dispenser panel, open freezer door until 4
phillips screws that hold the door trim in place are accessible.
Remove screws and slide out door trim. Close door and insert
replacement panel. Reinsert Torx screw and reinstall door trim.
Spill Tray
Grille
Fig. 9
One-piece Overlay/Frame Panel Installation:
See Owner Manual for switching "OFF / O" the unit. Reference Fig. 9 for door panel removal and installation. With panels removed
reattach hinge trim. Lift slide out Spill Tray grille and remove 2 Torx screws
screws from the control panel
dispenser terminal inside to avoid interfering with one-piece panel
control panel to dispenser terminal. Reattach control panel with 2 Torx screws. Reposition stainless steel liner into track and secure
with 2 Torx screws. Reinstall the Spill Tray grille and door trim. Turn unit on.
. Slide control panel down to remove. Disconnect terminals on back of control panel
Grille Panel
46
"
1/4
40
"
1/4
Upper Freezer
20
Door Panel
15/16"
(48)2 (48)3
9/16" 7/16"
(42)2 (42)1
7/16" 5/16"
13
13/16"
69
1/8"
Lower Freezer
34"
Door Panel
(48)17
"
5/16
(42)15
1/16"
, . Remove stainless steel liner
. Open door and slide one-piece panel into position. Reconnect
4
8
3/4"
Refrigerator
Door Panel
Side Panel
82
13/16"
(Dimensions Typ.)
1
3/8"
3/8"
26
"
1/16
22
5/16"
2
2
"
7/16
. Remove 2 Torx
. Tuck
1/2"
24"
Fig. 10