Epson FX-80 Operation Manual page 95

ESC C
'~61"t1
ESC C - Form length setting by number of lines
1*l.li4&1",,1
CHR$(27);
"c"
;CHR$(n);
(1
~ n ~
127)
umlau.];,
Sets form length by number of lines.
This code specifies the form length by number of lines.
Form feed, skip-over perforation, etc., are carried out in accordance
with the form length specified by this code.
The form length will be stored as an absolute length with the amount
of line spacing multiplied by the specified number of lines. Therefore,
the specified form length will not change after it has once been set
even if the amount of line spacing is changed.
'iihijdliJ
ESC C
Set the form length to 50 lines.
LPRINT CHR$(27);IC" ;CHR$(50);
3-44