Casing It Up - Ramsey Electronics WSR-1A Assembly And Instruction Manual

CASING IT UP

1. Locate the case and knob parts. The following is what you should have:
1 Rear panel with square hole
1 Front panel with the volume hole
4 Machine screws
2 Plastic panel holders
1 Top section of case
1 Bottom section of case
3 Decorative push button caps
2 Knobs
2. Slide the PC board into the slots on the aluminum bottom piece of the
case, parts side up.
3. Using the front panel, line up the LEDs to their respective holes.
4. Remove the front panel, then mount the cover of the case to the bottom
part by sliding the aluminum part into the cover.
5. Using one of the plastic panel holders, place the front panel into the side
of the plastic holder that it fits into. Make sure the holes line up.
6. Align the front panel with the case, knobs, and the mounting holes in the
case.
7. Use two of the screws provided to hold the front panel in place.
8. Repeat steps 5-7 for the rear panel.
9. Making sure the panels are securely in place and everything is aligned,
you can place the volume knob on the volume control. To do this, turn the
knob all the way up, then place the knob on with the notch pointing at the
highest tick on the panel.
10. Now to finish her up, place all of the push button caps on all three of the
switches.
11. Stand back and admire your work!
12. Show it off to your friends and family if you so desire.
WSR-1A• 22