Timer Setting - Panasonic NN-S262 Operating Instructions Manual

Timer Setting

This feature allows you to program a Standing Time after
cooking is completed and to program the oven as a
kitchen timer and/or to program a delay start.
To Use as a Kitchen Timer:
Example: To count 5 minutes
1. • Press.
2. • Set desired amount of time
3. • Press.
To Set Stand Time:
Example: To stand for 5 mins. after cooking (3
mins. at P6 Power)
1. • Enter the desired cooking
5 times.
2. • Press once.
3. • Set desired amount of Stand
4. • Press.
OPERATION
using number pads.
(up to 99 minutes and 99
seconds).
Time will count down without
oven operating.
program (see page 13 for
directions).
Time using number pads. (up to
99 minutes and 99 seconds)
Cooking will start. After
cooking, stand time will count
down without oven operating.
To Set Delay Start:
Example: To start cooking 5 minutes later.
(3 mins. at P6 Power).
1.
2.
3.
5 times.
4.
NOTES:
1. When each stage finishes, a two-beep signal sounds.
At the end of the program, the oven will beep five
times.
2. If oven door is opened during Stand Time or Kitchen
Timer, the time on the Display Window will continue
to count down.
3. Stand time and Delay time cannot be programmed
before any Auto Control Function. This is to prevent
the starting temperature of food from rising before
defrosting or cooking begins. A change in starting
temperature could cause inaccurate results.
- 21 -
• Press once.
• Enter desired amount of
delayed time using number
pads.
(up to 99 minutes and 99
seconds)
• Enter the desired cooking
program (see page 13 for
directions).
• Press.
Delayed time will count down.
Then cooking will start.