Mounting Hood Cover (Provided); Adjusting Position; Outputting Images; Adjusting Picture Quality - JVC ViewFinder VF-HP840U Instructions Manual

Setup
Installation (continued)

Mounting hood cover (provided)

1
Align the hood cover with the groove on top of the
viewfinder screen and insert from the top.
2
Secure with the screw found under the center of the
viewfinder screen.
Screw

Adjusting position

1
To adjust the angle of the viewfinder, loosen the Pan/
Tilt Lock Handle and secure it at an appropriate angle
for visible viewing.
Note ：
● The LCD screen may be difficult to see depending on the
view angle. Use the angle right in front of the screen.
Tilt
Panning and Tilt Lock Handle
10
Panning

Outputting images

1
When setting the POWER switch on remote control
or camera to AONB, image will be output on the
viewfinder.
Note ：
● Depending on the system environment, it may take up to 40
seconds before the image is output.

Adjusting picture quality

1
Turn the [BRIGHT] control to adjust the
brightness of the screen.
To brighten, turn to the right.
Caution ：
● If the [BRIGHT] control is turned completely to the left,
images may not be output.
2
Turn the [CONTRAST] control to adjust the
contrast of the screen.
To increase the contrast, turn to the right.
3
Turn the [PEAKING] control to adjust the peaking.
To sharpen the contour, turn to the right.
Note ：
● You can adjust the freqency band where the contour is
emphasized with the [PEAKING] control under the
[PEAKING FREQ.] item of the [SHOOTING ASSIST] menu
screen. (A Page 14)
Caution ：
● After the power switch of the camera or the remote control
unit is turned off, wait for 10 seconds and above to turn on
the switch again.
● Turning ON/OFF the power switch quickly may cause
malfunction.
MENU
STATUS
[BRIGHT] control
BRIGHT
[CONTRAST] control
CONTRAST
[PEAKING] control
PEAKING
1:1
FOCUS
ASSIST