Desa CGEFP33PRA Owner's Operation And Installation Manual page 22

INSTALLATION
22
Installing Logs (VTGF33NR/VTGF33PR) (Cont.)
Installing Logs (CGEFP33PRA/CGEFP33NRA)
INSTALLATION
Continued
Rear
Peg
Log (#3)
Groove
Groove
in Back
in Back
of Log
of Log
Grate
Prong
Figure 43 - Installing
Rear Log (#3)
INSTALLING LOGS (CGEFP33PRA/
CGEFP33NRA)
WARNING: Failure to position the parts in accor-
dance with these diagrams or failure to use only parts
specifically approved with this heater may result in
property damage or personal injury.
CAUTION: Do not remove the warning and in-
struction labels attached to the heater base assem-
bly. These markings contain important warranty in-
formation.
CAUTION: After installation and periodically there-
after, check to ensure that no flame comes in contact
with any log. With the heater set to HIGH, check to see
if flames contact any log. If so, reposition logs ac-
cording to the log installation instructions in this
manual. Flames contacting logs will create soot.
Each log is marked with a number. These numbers will help you
identify the log when installing. It is very important to install these
logs exactly as instructed. Do not modify logs. Only use logs
supplied with heater.
1. Locate pegs on the bottom of back log (#1). Slide these pegs into
the holes in the grate base behind the burner (see Figure 45).
2. Place the base of the middle log (#2) in the U-shaped slots of
the grate base in front of the back log. The cutout on the right
of the middle log should fit over the burner (see Figure 46).
Make sure the front of the middle log is resting on the tabs of
the grate base and the cutout area is centered over the burner
"U" bend.
For more information, visit www.desatech.com
For more information, visit www.desatech.com
Crossover
Log (#4)
Hole
Cutout
Peg
Grate
Prong
Figure 44 - Installing
Crossover Log (#4)
3. Locate the recesses on the back of the front log (#3). Fit these
recesses between the posts of the grate base (see Figure 47).
4. Locate the notches in the bottom of the crossover log (#4). Place
the crossover log on top of the middle log and front log. Make
sure the notches of the crossover log lines up with rectangular
knobs on top of the middle and front logs (see Figure 48).
Back
Log
(#1)
Hole in
Grate
Base
Figure 45 - Installing Back
Log (#1)
Front Log (#3)
Recess
Post
Figure 47 - Installing Front
Log (#3)
Middle
Log
(#2)
Tab
Burner
Burner
U-Shaped Slot
Figure 46 - Installing Middle
Log (#2)
Crossover
Log (#4)
Rectangular
Knobs
Post
Figure 48 - Installing
Crossover Log (#4)
Cutout
"U" Bend
110149-01A