Mercedes-Benz SLK Operator's Manual page 341

The collapsible spare wheel must be
mounted before it is inflated.
Pull plug ? out of the housing.
X
Take the air hose out of the housing.
X
Insert the yellow hose connector of the air
X
hose into the guide in the housing and push
it into the fixture until the hose connector
engages.
Remove the cap from the valve on the
X
collapsible spare wheel.
Screw union nut : on the air hose onto the
X
valve.
Make sure the tire inflation compressor's
X
on/off switch A is set to OFF.
Insert plug ? into the socket of the
X
cigarette lighter or into a 12 V power socket
in your vehicle.
Observe the notes on the cigarette lighter
( page 258). Observe the notes on
Y
sockets ( page 258).
Y
Turn the SmartKey to position 1 in the
X
ignition lock ( page 139).
Y
Press on/off switch A on the tire inflation
X
compressor to ON.
The tire inflation compressor is switched
on. The tire is inflated. The tire pressure is
shown on pressure gauge =.
Inflate the tire to the specified tire
X
pressure.
The specified tire pressure is printed on the
yellow label of the emergency spare wheel.
When the specified tire pressure has been
X
reached, press on/off switch A to OFF, on
the tire inflation compressor.
The tire inflation compressor is switched
off.
Turn the SmartKey to position 0 in the
X
ignition lock.
If the tire pressure is higher than the
X
specified pressure, press pressure release
button ; until the correct tire pressure has
been reached.
Emergency spare wheel
Unscrew union nut : on the air hose from
X
the valve.
Screw the cap onto the valve of the
X
collapsible spare wheel again.
Removing an air hose
To remove the hose from the tire inflation
X
compressor, push down the rocker switch
on the hose connector and pull out the
hose.
Stow plug ? and the air hose in the lower
X
section of the blower housing.
Stow the tire inflation compressor in the
X
vehicle.
I n f o r m a t i o n P r o v i d e d b y :
339
Z