Getting Familiar With Your Grill; Caring For Your Equipment; Installation - Fiesta Outdoor Gas Barbeque / Grill Use And Care Manual

GETTING FAMILIAR WITH YOUR GRILL

WARNING
BEFORE YOU USE THIS APPLIANCE
• Your grill is properly assembled.
• There are no leaks in the gas supply system (see 'Leak Testing' section).
• The burner is properly assembled with the venturi tubes seated over the valve
outlets (Figure 1 below) and there are no blockages present in the venturi tubes
(see 'Cleaning Venturi Tubes' section).
• Electrical supply cords and/or gas supply hoses are kept away from any
heated surfaces.
• Your grill is positioned in a safe location (see 'Installation' section).
Figure 1.
• Ensure valve outlets (orifices)
are assembled 3/8" (1 cm)
into the venturi tubes.
• Check to see that the valve
outlets and venturi tubes are
parallel to the bottom of the
base casting of your
appliance.
WARNING

CARING FOR YOUR EQUIPMENT

INSTALLATION

THE INSTALLATION OF THIS APPLIANCE MUST CONFORM WITH LOCAL CODES OR, IN THE
ABSENCE OF LOCAL CODES:
• In Canada: must conform to CAN/CGA - B149.2 Propane Installation Code or
CAN/CGA B149.1 Natural Gas Installation.
• In the U.S.A.: must conform to National Fuel Gas Code ANSI Z223.1.
WARNING
• 24 inches (61 cm) from side of unit (See Figure 2)
• 18 inches (46 cm) from back of unit (See Figure 2)
DO NOT USE YOUR GRILL UNTIL YOU HAVE READ AND
UNDERSTOOD ALL THE INFORMATION IN THIS MANUAL.
IT IS EXTREMELY IMPORTANT TO BE SURE THAT:
FAILURE TO ENSURE THE ABOVE MAY RESULT IN A HAZARDOUS
FIRE OR EXPLOSION CAUSING SERIOUS BODILY INJURY AND/OR
PROPERTY DAMAGE.
WHEN DECIDING WHERE TO PLACE YOUR APPLIANCE, FOLLOW
THESE MINIMUM CLEARANCE DISTANCES TO ADJACENT
COMBUSTIBLE MATERIALS:
Fig. 1
CASTING
3/8"
3
VENTURI
TUBE
AIR SLEEVE
VALVE OUTLETS