Operating Instructions For Timer Models; Programming - Timer Models - Antunes, AJ Series 9100100 Owner's Manual

DELUXE FOOD WARMER
WARNING
To avoid injury, be careful when opening top
cover. Be sure to allow steam to escape before
putting hands or face over the steamer.
�����
Figure 6. Operating Controls Non-Timer Models
OPERATION (continued)

Programming - Timer Models

CYC (Total Cycle Time) refers to the total amount of
steaming time set for the product.
SHO (Shot Interval Time) is the time set between
shots of steam during a complete cycle.
H2O Setting (Steam Shot Time) is used to adjust the
water volume used during each pump/solenoid opera-
tion.
The amount of steam produced by your Deluxe Food
Warmer (steamer) depends on the amount of water
sprayed onto the steam generator.
Flooding of the generator may occur if the H2O setting
is set too high. To prevent this from occurring, the Shot
Interval Time (SHO) may be increased to allow more
time for generator heat recovery. Adjustments should
be made to both values to determine the optimum set-
tings for your cooking needs.
To program the control, refer to Figure 7 and use the
following procedure in sequence:
1. Turn the Rocker Switch (power On/Off) to ON.
2. Press and release the Program button to change
3. To change the Total Cycle Time in minutes, use
4. Press and release the Program button again and
5. To change the SHO factory settings, make sure
Operate
Button
Rocker Switch
(Power On/Off)
6. Press and release the Program button and use
NOTE: 20 seconds is recommended.
12
The display shows the factory programmed Total
Cycle Time in minutes and seconds (Item A,
Figure 7).
the control from OPERATION to PROGRAM
mode.
the UP or DOWN arrow buttons to change the
time (Item B, Figure 7).
use the UP or DOWN arrow buttons to change the
Total Cycle Time in seconds (Item C, Figure 7).
the control is in PROGRAM model, then press
and hold the two arrow buttons simultaneously for
1-2 seconds and then release. SHO will be dis-
played (Item D, Figure 7).
the UP or DOWN arrow buttons to change the
SHO setting in seconds (Item E, Figure 7).
P/N 1010678 Rev. F 09/04