AMD Athlon Installation Manual page 17

Socket a amd processor

Hide thumbs Also See for Athlon:

23986—December 2000

19. No matter which tool is used, the clip must be aligned with the center socket lugs

for the clip to fit. Figure 19 shows the clip aligned with the lug. This alignment is

essential for the clip to lock. Otherwise, the clip may only be held in place by one

side of the lug and the clip will eventually come loose.

Caution: Make sure that the clip has been lifted over the tab so that it is fully engaged

and not simply resting on the edge of the center socket tab. Improper installation can

cause the socket tab to break.

Note: Inspect the socket and the clip from both the side (profile) view and top view

(from above) to verify the proper installation.

If this is a test-fit operation, to remove the heatsink simply push the clip down and

it will (normally) spring off the lug. If it does not, use the insertion tool and

reverse the installation procedure.

Figure 19. Make Sure that the Clip is Aligned With the Lug

Socket A AMD Processor Installation Guide

Clip and lug must be aligned.

Table of Contents

Duron