Cadillac 2013 Escalade Owner Manual M page 227

2. Set the driver and passenger
temperature.
To find your comfort setting, start
with a 23°C (74°F) temperature
setting and allow about
20 minutes for the system to
regulate. Use the driver or
passenger temperature buttons
to adjust the temperature setting
as necessary. If a temperature
setting of 15°C (60°F) is chosen,
the system remains at the
maximum cooling setting. If a
temperature setting of 32°C
(90°F) is chosen, the system
remains at the maximum heat
setting. Choosing either
maximum setting will not cause
the vehicle to heat or cool any
faster.
Be careful not to cover the sensor
located on the top of the instrument
panel near the windscreen. This
sensor regulates air temperature
based on sun load and also turns
on the headlamps.
To avoid blowing cold air in cold
weather, the system will delay
turning on the fan until warm air is
available. The length of delay
depends on the engine coolant
temperature. Pressing the fan
switch will override this delay and
change the fan to a selected speed.
Manual Operation
y 9 z
(Fan Control): Press the
up or down arrows to increase or
decrease the fan speed
Pressing this button when the
system is off will turn the system on.
Pressing either arrow while using
automatic operation will place the
fan in manual operation. The fan
setting will display and the AUTO
light will turn off. The air delivery will
remain in automatic operation.
z
(Air Delivery Mode Control):
Press to change the direction of the
airflow in the vehicle. Repeatedly
press the button until the desired
mode appears on the display.
Climate Controls
When the system is turned off, the
display goes blank after displaying
the current status of the system.
H
(Vent): Air is directed to the
instrument panel outlets.
)
(Bi-Level): Air is divided
between the instrument panel and
floor outlets. Some air is directed
towards the windscreen and side
window outlets. Cooler air is
directed to the upper vents and
warmer air to the floor vents.
6
(Floor): Air is directed to the
floor outlets, with some to the
windscreen, side window outlets,
and second row floor outlets. In this
mode, the system automatically
selects outside air.
-
(Demist): This mode clears the
windows of mist or moisture. Air is
directed to the windscreen, floor
outlets, and side window vents. In
this mode, the system turns off
recirculation and runs the air
conditioning compressor unless the
outside temperature is close to
8-3