Connecting The Ipcmpr/Ipcempr/Ip-Ext16 Card To The Lan - Panasonic KX-TDE100 Network Manual

3.1 Connecting the IPCMPR/IPCEMPR/IP-EXT16 Card to the LAN

3.1 Connecting the IPCMPR/IPCEMPR/IP-EXT16
Card to the LAN
Refer to the following example to connect the IPCMPR/IPCEMPR/IP-EXT16 card to the LAN.
When IPCMPR/IPCEMPR/IP-EXT16 cards are connected to the LAN for the first time, you must assign IP
addressing information to them. Refer to "4.1 Programming the IPCMPR/IPCEMPR Card"
or "4.2 Programming the IP-EXT16 Card" for instructions respectively.
Note
•
Use an Ethernet straight cable with an RJ45 connector to connect the card to a switching hub. The
cable should be a 10BASE-T/100BASE-TX CAT 5 (Category 5) or higher cable.
•
Before connecting the card, attach the included ferrite core to the cable.
•
Make sure to set the port of the switching hub that connects to the card to operate under "Auto
Negotiation" mode.
•
When using the VLAN feature on the network, make sure that the card is connected to a layer 2 switch
that is IEEE 802.1Q compliant, and that is configured for VLANs. In addition, the port of the switching
hub to which the card is connected must be set to "Untagged". Consult your network administrator for
details.
•
To use a KX-NT265, make sure that the Local Processor (LPR) software of the IP-EXT16 card is as
follows:
–
PIPEXT Software Version 1.001 or later.
–
PVOIPEX Software Version 1.011 or later.
•
To use a KX-NT300 series IP-PT, make sure that the LPR software of the IP-EXT16 card is as follows:
–
PIPEXT Software Version 2.000 or later.
–
PVOIPEX Software Version 2.000 or later.
Attaching a ferrite core to the cable
1.
Wrap the cable once around the ferrite core, leaving a space between the ferrite core and the connector
as specified below.
2.
Close the case of the ferrite core.
28 IP Networking Guide
3 cm
For IPCMPR/IPCEMPR Card
5 cm
OR
For IP-EXT16 Card