Protection Circuitry - Technics SA-EH760 Service Manual

file:///C|/Documents%20and%20Settings/Administrator/Plocha/SA-EH760/s0200000000x.htm

2 Protection Circuitry

TOP PREVIOUS NEXT
The protection circuitry may have operated if either of the following conditions is noticed:
No sound is heard when the power is switched ON.
Sound stops during a performance.
The functions of this circuitry is to prevent circuitry damage if, for example, the positive and negative
speaker connection wires are shorted, or if speaker systems with an impedance less than the indicated
rated impedance of this unit are used.
If this occurs, follow the procedures outlined below.
1. Switch OFF the power.
2. Determine the cause of the problem and correct it.
3. Switch ON the power once again.
Note:
When the protection circuitry functions, the unit will not operate unless the power is first switched OFF
and then ON again.
•@
TOP PREVIOUS NEXT
file:///C|/Documents%20and%20Settings/Administrator/Plocha/SA-EH760/s0200000000x.htm [2.4.2003 3:39:00]
Jeanne van Woerkom electra
www.freeservicemanuals.info