JVC LYT0002-088B Instructions Manual page 20

20
EN
Recording From The Middle Of A Tape
When removing a tape on which you were recording, or when you resume recording on a tape after playing
back the recording previously made (without taking the tape out between recordings), perform this
procedure.
LCD monitor
STOP PLAY REW
PLAY/PAUSE
STOP
1
OPEN LCD MONITOR
Make sure the LCD monitor is open fully.
2
SELECT MODE
Press down the lock button located on the
Power Dial and turn the Power Dial to "PLAY".
3 START SEARCH
Press PLAY/PAUSE, then press REW or FF.
Watch in the LCD monitor for the spot where
you want to begin recording.
4 ENGAGE STILL MODE
Once you find the spot at which you want to
start recording, press PLAY/PAUSE to engage
the Still mode.
FF
REW FF
RECORDING
Lock button
Power Dial
5
START RECORDING
Set the Power Dial to "REC" and press
RECORDING START/STOP.
•Start recording from a point prior to the end
of the last recording. A few seconds of the
end of the last recording will be erased.
NOTE:
If you start recording from the end of the previous
recording leaving no blank space, there may be
situations where a clean transition is not possible.
(Cont.)
RECORDING
START/STOP Button