Additional Cli Commands For The Fortiusb Key; Testing A New Firmware Image Before Installing It - Fortinet FortiGate-800 Install Manual
Fortios 3.0mr4
Hide thumbs
Also See for FortiGate-800:
- Administration manual (392 pages) ,
- Installation and configuration manual (336 pages) ,
- Install manual (56 pages)
Table of Contents
Advertisement
Testing a new firmware image before installing it
Additional CLI Commands for the FortiUSB key
Testing a new firmware image before installing it
58
3
Select the following:
•
On system restart, automatically update FortiGate configuration file if default
file name is available on the USB disk.
•
On system restart, automatically update FortiGate firmware image if default
image is available on the USB disk.
4
Enter the configuration and image filenames or use the default configuration
filename (system.conf) and default image name (image.out).
5
The default configuration filename should show in the Default configuration file
name field.
6
Select Apply.
To configure the USB Auto-Install using the CLI
1
Log into the CLI.
2
Enter the following command:
config system auto-install
set default-config-file <filename>
set auto-intall-config {enable | disable}
set default-image-file <filename>
set auto-install-image {enable | disable}
end
3
Enter the following command to see the new firmware installation settings:
get system status
Use the following CLI commands when you want to delete a file from the FortiUSB
key, list what files are on the key, including formatting the key or renaming a file:
• exec usb-disk list
• exec usb-disk delete <filename>
• exec usb-disk format
• exec usb-disk rename <old_filename1> <old_filename2>
Note: If you are trying to delete a configuration file from the CLI command interface, and
the filename contains spaces, you will need quotations around the filename before you can
delete the file from the FortiUSB key.
Test a new firmware image by installing the firmware image from a system reboot
and saving it to system memory. After completing this procedure, the FortiGate
unit operates using the new firmware image with the current configuration. This
new firmware image is not permanently installed. The next time the FortiGate unit
restarts, it operates with the originally installed firmware image using the current
configuration. If the new firmware image operates successfully, you can install it
permanently using the procedure
page
49.
"Upgrading to a new firmware version" on
FortiGate-800 and FortiGate-800F FortiOS 3.0MR4 Install Guide
FortiGate Firmware
01-30004-0269-20070215
Advertisement
Table of Contents
