Finding A Station; Playing The Radio - Hummer 2004 H2 User Manual

Navigation Audio System
The audio system has been designed to operate easily
and give years of listening pleasure. You will get the
most enjoyment out of it if you acquaint yourself with it
first. Find out what your audio system can do and
how to operate all its features, to be sure you're getting
the most out of the advanced engineering that went
into it.
The ignition must be in ACCESSORY or RUN for your
audio system to work.
The audio system is operated using the menus located
on the navigation system screen. The audio menus
are explained in this section.

Playing the Radio

The audio system can be operated using the knobs and
hard keys located on both sides of the navigation
screen. See the navigation system overview under
Introduction on page 1-2 for more information on
location.
O
(Power/Volume): Press this knob to turn the audio
and navigation systems on and off. While the audio
system is on, you can turn the knob clockwise or
counterclockwise to increase or decrease the volume.
3-2

Finding a Station

BAND: Press this key to access the BAND screen and
to switch between AM, FM1, FM2, or XM1 and XM2,
if equipped. Each radio band has six station presets
accessible.
TUNE: Use the joystick in the lower left corner of the
navigation system to choose a radio station.
w x
SEEK : Press the up or the down arrow to go to
the next or to the previous station and stay there.
To scan stations, press and hold the SEEK up or down
arrow for two seconds until you hear a beep. The
radio will go to a station, play for a few seconds, then
go on to the next station. Press either SEEK arrow again
to stop scanning.
To scan preset stations, press and hold the SEEK up or
down arrow for more than four seconds. You will hear
two beeps and PSCAN will be displayed, along with the
highlighted preset. The radio will go to one of the
preset stations, play for a few seconds, then go on to
the next preset station. Press either SEEK arrow
again to stop scanning presets.
The radio will seek and scan only to stations that are in
the selected band and only to those with a strong
signal.