Heated Handles - Husqvarna 357XPG E-tech Operator's Manual

For temperatures below -5°C and/or in snow conditions
there is also:
• a special cover (A) for the starter housing
• a winter plug (B) for the air nozzle that is fitted as
shown.
These reduce the flow of cooling air and prevent large
amounts of snow from being sucked into the carburettor
space.
CAUTION! When the winter plug is fitted the winter flap
must be open!
IMPORTANT! If the temperature rises above -5°C or 0°C
respectively the machine MUST be restored to its
normal set-up. Otherwise there is a risk of overheating,
which can cause severe engine damage.

Heated handles

(357 XPG, 359 G)
On models with the designation XPG/G, the front as well
as the rear handle are equipped with electric heating
coils. These are supplied with electricity from a built-in
generator on the chain saw.
When the switch is pushed downwards, the heat is
switched on. When the switch is pushed upwards, the
heat is switched off.
Electrical carburettor heating
(357 XPG, 359 G)
On models with the designation CARBURETOR
HEATING there is an electrically heated carburetor.
Electrically powered heating prevents ice formation in the
carburetor. A thermostat regulates the heating so that the
carburetor always has the right working temperature.
MAINTENANCE
–
English 39