Dimplex ESTHETIC SERIES Instructions

"ESTHETIC" CONVECTOR HEATER SERIES
STEP-BY-STEP INSTALLATION
WARNING
The installation of the convector heater must comply with the applicable
Local and/or National Electrical Codes and utility requirements. This
installation should be entrusted to duly qualified personnel where required
by law.
NOTE
Due to the precision of the convector's control circuits, the unit is highly
sensitive to air drafts, cold floors, etc. To ensure the thermostat operates
efficiently, be sure to carefully choose the units location before installing.
Avoid installing unit in an area that is susceptible to cold drafts, or near a
cold floor.
WARNING
The convector must be installed in a location preventing anyone using a
bath or shower from touching the control devices.
WARNING
The convector must not be located directly below a fixed power outlet.
CAUTION
The minimum distances between the convector and any object in its
immediate vicinity must be observed to ensure correct operation (Figure 1).
1. Remove the tie wrap from electric cable.
2. Remove the mounting bracket from the rear of the convector casing by
squeezing the release tabs at the top of the bracket and pulling out of
the casing.
3. Place the bracket on the wall at the desired location, and mark the
mounting hole locations using the bracket as a template (Figure 2).
4. Secure the mounting bracket to the wall (Figure 2) using suitable
screws (not included).
5. Install a power receptacle box on the wall next to the convector
mounting bracket.
NOTE
The heater can be installed so the wall receptacle box can be hidden.
6. Feed the power supply wiring into the power receptacle box.
7. Install the convector onto the bottom tabs of the mounting bracket.
8. Snap the top of the convector casing onto the top tabs to secure the
convector to the bracket.
9. Connect the power supply wiring to the convector heater wiring
(Figure 3).
10. Install receptacle box cover.
NOTE
If the power receptacle box is located behind the heater the heater is to be
wire connected and then installed to the mounting bracket.

SAFETY PRECAUTIONS

WARNING
Secure convention heater to wall bracket before using.
1. Do not cover your heating unit in any way. The "DO NOT COVER"
warning tag is there to remind you that any materials covering the
units can catch fire.
2. Do not mask the heating unit with furniture or curtains, as this will
interfere with the operation of the convector.
3.
Regularly clean and dust the inlet and outlet grid.
(Note: Please read all instructions before installing)
7204310000REV02
FIGURE 1
FIGURE 2
WHITE WIRE – POWER
BLACK WIRE – POWER
GREEN WIRE – GROUND
FIGURE 3
1