Automatic Shut-Off / Troubleshooting - Venta Airwasher LW15 User Manual

• C leaning of disk stacks – Soaking the disk stacks in hot water with Venta Cleaner or white
vinegar for approx. 30 minutes will help loosen any buildup of calcium or lime. Always rinse
with warm tap water after cleaning.
• V inegar and Water Solution – either a 50:50 or a 3:1 ratio of white vinegar and water can be
used instead of the Venta Cleaning Solution.
• Do not use the appliance in an environment with temperatures consistently over 95
degrees Fahrenheit.
automatiC shut-oFF
The appliance has an automatic shut-off feature that is indicated by displaying 4 .
The appliance will shut
off automatically if:
there is too little water in the
lower housing.
the upper housing has been
opened.
the upper housing is not in-
stalled or is not properly fitted
to the lower housing
trouBleshooting
Problem Possible causes
Appliance does not 1. Switching power supply not
function
2. Mains cable connector not
Operation indica- Motor/Gearing malfunction
2
tion flashes
problem: CliCKing noise
• M ake sure the rubber coupling is inserted all the way into the gear.
• I f a mineral deposit has formed inside the gear, this could cause a clicking sound during op-
eration. Call our customer service department toll-free at (888) 333 8218 for a replacement.
problem: wetness around the applianCe
• T urn the empty lower housing upside down to dry. This will allow any excess water that col-
lected between the double walls to empty out the weep holes. Allow at least 24 hours to dry.
problem: disK staCK not turning
• C heck that the rubber coupling is properly inserted into the bottom of the gear.
What to do
Switch off appliance, disconnect switching power supply, top
up with water and start operation again with button 1 . See
also „Maintenance and cleaning", „Daily"
Close top cover again by pressing on the external ends of the
latches. Switch the appliance on and off with button 1 .
Place top cover onto lower container. Switch the appliance
on and off with button 1 .
connected
plugged and latched into drive unit.
What to do
1. Connect switching power supply to mains
socket, switch on appliance with button
2. Plug mains cable connector into drive unit
until it latches.
Please get in touch with Customer Service
Tel. 1-888-333-8218
13
1