Memorex MVT2135B D Series Service Manual page 13

2-13: AHC ASS'Y/CYLINDER UNIT ASS'Y
(Refer to Fig. 2-13)
Unlock the support 1 and remove the AHC Ass'y.
1.
2. Disconnect the following connector:
(CD2001)
Remove the 3 screws 2.
3.
4. Remove the Cylinder Unit Ass'y.
NOTE
1. When you install the Cylinder Unit Ass'y, tighten the
screws from (1) to (3) in order while pulling the Ass'y
toward the left front direction.
Cylinder Unit Ass'y
(1)
2
• Screw Torque: 3 ± 0.5kgf•cm
2-14: CAPSTAN DD UNIT (Refer to Fig. 2-14)
1. Remove the Capstan Belt.
Remove the 3 screws 1.
2.
3. Remove the Capstan DD Unit.
1
• Screw Torque: 4 ± 0.5kgf•cm
DISASSEMBLY INSTRUCTIONS
AHC Ass'y
1
(3)
2
(2)
2
Fig. 2-13
Capstan Belt
Capstan DD Unit
1
1
Fig. 2-14
2-15: MAIN CAM/PINCH ROLLER CAM/JOINT GEAR
(Refer to Fig. 2-15-A)
Remove the E-Ring 1, then remove the Main Cam.
1.
Remove the E-Ring 2, then remove the Pinch Roller
2.
Cam and Joint Gear.
NOTE
1. In case of the Pinch Roller Cam and Main Cam
installation, install them as the circled section of Fig. 2-
15-B so that the each markers are met. (Refer to Fig.
2-15-B)
Pinch Roller Cam
Marker
Main Cam
2-16: LOADING GEAR S/T ASS'Y (Refer to Fig. 2-16-A)
Remove the E-Ring 1 and remove the Main Loading
1.
Gear.
Remove the Main Rod, Tension Lever, Loading Arm S
2.
Ass'y and Loading Arm T Ass'y.
Main Rod
Tension Lever
B2-5
1
Main Cam
2
Pinch Roller Cam
Joint Gear
Fig. 2-15-A
Fig. 2-15-B
1
Main Loading Gear
Loading Arm T Ass'y
Loading Arm S Ass'y
Fig. 2-16-A