Table of Contents
Advertisement
48
EN
System Select Switch
Power lamp
To move
the page next
Power Switch
Display
To move
the page back
D.S.C. PLAYBACK
Still images shot using this camcoder are automatically
numbered, then stored in numerical order in the built-in
memory. You can view the still images stored in memory,
one at a time, much like flipping through a photo album.
1
SELECT OPERATION SYSTEM AND
MODE
Set the System Select Switch to "D.S.C.", and set the
Power Switch to "PLAY".
•The power lamp lights.
•The still image stored in memory is displayed.
•When no still image is stored in memory, the screen
becomes blue.
2
PLAY BACK
Press FF (3/PAGE+) or REW (2/PAGE–) to select
the still image you want to view.
•Each time REW (2/PAGE–) is pressed, the page
goes back, while each time FF (3/PAGE+) is
pressed, the page goes next.
•Even if you shoot a new picture after playing back a
still image with a low number, this will not
overwrite the existing picture because new pictures
are automatically stored after the still image most
recently stored in memory.
NOTES:
When the Power Switch is set to "PLAY" and the LCD
monitor is opened at an angle of 60 degrees or more, the
LCD monitor switches on and the viewfinder switches
off automatically to save power.
The playback picture can also be viewed in the
viewfinder (with the LCD monitor shut) or on a
connected TV (
pg. 46, 47). Camcorder operation is
the same as described in this section.
When viewing a playback picture on a connected TV, it
may jitter slightly.
You can also view the playback picture on the LCD
monitor with it flipped over and retracted.
Basic Playback
Advertisement
Table of Contents
