JVC GR-FX16 Instructions Manual page 15

Connections To A TV/VCR
1) Make sure all units are turned off.
2) Connect the camcorder to a TV or VCR. If using
both TV and VCR, connect the VCR output to
the TV input.
3) Turn on all units. Set the VCR to its AUX input
mode, and set the TV to its VIDEO mode.
• Use the AC Adapter as the power supply.
• Be sure to adjust the TV sound volume to its
minimum level to avoid a sudden burst of sound
when the camcorder is turned on.
• If you have a TV or speakers that are not
specially shielded, do not place the speakers
adjacent to the TV as interference will occur in the
camcorder playback picture.
• If your TV/VCR has a 21-pin connector, use the
provided Cable Adapter.
• The S-Video cable connection can improve the
dubbed picture quality. If your TV/VCR has a
21-pin connector, use a commercially available
cable adapter with an S-Video connector
(GR-SXM50/SX26 only)
To S-Video
5
Output
Connector cover
S-Video
cable
To S-Video
Input
.
White to
Audio
Output
Yellow to
Video
Output
A/V cable
TV
White to
Audio Input
VCR
Yellow to
Video Input
Tape Dubbing
1) Connect the camcorder and the VCR
( "Connections To A TV/VCR"). Set the Power
@
Switch
Lock Button
VCR's power, and insert the appropriate
cassettes in the camcorder and the VCR.
Engage the VCR's AUX and Record-Pause
modes.
2) Press 4/6
in point. Once it is reached, press 4/6
3) Press 4/6
mode.
4) Engage the VCR's Record-Pause mode and
press 4/6
• Repeat steps 2) through 4) for additional editing,
then stop the VCR and camcorder when finished.
6
7
15
to " " while pressing down the
!
located on the switch, turn on the
&
to find a spot just before the edit-
&
and engage the VCR's Record
&
.
&
again.