Battery Replacement; Audio/Video (A/V) Jacks; Changing The Source On The Video Display Screens - Chevrolet 2011 Equinox Navigation System Navigation Manual

46 Infotainment System
If the foam ear pads attached to
the headphones become worn or
damaged, the pads can be replaced
separately from the headphone set.
To purchase replacement ear pads,
contact your dealer.

Battery Replacement

To change the batteries:
1. Loosen the screw to the battery
door located on the left side of
the headphones.
2. Slide the battery door open.
3. Replace the two AAA batteries.
4. Replace the battery door and
tighten the screw.
Remove the batteries if the
headphones are not going to be
used for a long period of time.

Audio/Video (A/V) Jacks

If available, the A/V jacks are
located on the rear of the floor
console. They allow audio or
video cables to be connected
from an auxiliary device such
as a camcorder or a video game
system.
The A/V jacks are color coded:
Yellow for video input.
White for left audio input.
Red for right audio input.
Power for auxiliary devices is not
supplied by the infotainment system.
To use the auxiliary inputs of the
RSE system:
1. Connect the auxiliary device
cables to the A/V jacks.
2. Power on both the auxiliary
device and the RSE video
screen.
Changing the Source on the Video
Display Screens
The image from the auxiliary device
can be switched between the video
display screens.
To change the display:
1. Press AUX on the remote
control to change the source
of both video screens from the
DVD player to the auxiliary
device.
2. Press AUX a second time to
change the left video screen
source to the DVD player and
the right video screen to the
auxiliary device.
3. Press AUX a third time to
change the left video screen
source to the auxiliary device
and the right video screen to
the DVD player.
4. Press AUX a fourth time to
change the source of both video
screens to the DVD player.