Rip Parameters And Defaults; Rip Global Parameters; Rip Interface Parameters - HP ProCurve 2910al Switch Manual

IP Routing Features
Configuring RIP
N o t e
3-28
ICMP Host Unreachable Message for Undeliverable ARPs. If the
routing switch receives an ARP request packet that it is unable to deliver to
the final destination because of the ARP timeout and no ARP response is
received (the routing switch knows of no route to the destination address),
the routing switch sends an ICMP Host Unreachable message to the source.

RIP Parameters and Defaults

The following tables list the RIP parameters, their default values, and where
to find configuration information.

RIP Global Parameters

3-3 lists the global RIP parameters and their default values.
Table 3-3.

RIP Global Parameters

Parameter Description
RIP state Routing Information Protocol V2-only.
auto-summary Enable/Disable advertisement of summarized routes.
metric Default metric for imported routes.
redistribution RIP can redistribute static and connected routes. (RIP
redistributes connected routes by default, when RIP is
enabled.)

RIP Interface Parameters

3-4 lists the VLAN interface RIP parameters and their default values.
Table 3-4.

RIP Interface Parameters

Parameter Description
RIP version The version of the protocol that is supported on the
interface.
The version can be one of the following:
• Version 1 only
• Version 2 only
• Version 1 or version 2
Default
Disabled
Enabled
1
Disabled
Default
V2-only