Table of Contents
Advertisement
! IMPORTANT !
When turning on controller do not press any buttons while the Player 3 indicator is flashing. The
chip initializes when the controller is first turned on and needs all triggers to be released.
Activating
Before the chip is ready to respond to any command, you must tell it to "activate" and become
r
A
ready to receive a command. To activate hold
and tap the
(Start) button. As you do
this the Player 4 indicator light will come on.
Selecting Modes
r
A
To select a mode, first activate the chip by holding
and tapping the
(Start) button so
the Player 4 LED comes on. You must activate the chip each time you want to change modes.
r
With the chip activated and the Player 4 LED turned on, hold
down and keep tapping the
2
r
(Left D-Pad) button however many times for the mode you want, and then release
.
r
2
r
To select Mode 11 you would hold
, tap
11 times, and then release
. The Player 3
2
r
LED will flash with each press of
, and then when releasing
will flash back the mode
number to confirm you are doing things correct. Slow flashes = 10, fast flashes = 1, so mode 11
is one slow flash, one fast flash.
Quick Enable / Disable
r+a
2
If at any point you want to quickly disable the chip, activate the chip (
) then press
without any other buttons pressed. The light will flash rapidly several times then go off. The
chip is now disabled. If you were previously in a mode and want to quickly get everything back
on, repeat the steps and it will re-enter where you left off.
Chip Modes
One feature that makes the Arbiter 3 Elite Controllers so powerful (not available on A3 LiTE
controllers) is the ability to totally change its list of modes, effectively making the chip like a
whole new product. For example some chips on the market have modes specifically for Call of
Duty, others a general all-rounder's, but no other chip has the ability to be all of those in one.
This is what the A3 'Chip Select' is. You can change the A3 into a Specific List of modes that
best suit you!
Master Reset
As the Arbiter 3 has many Features that can be turned on and off and rapid fire speeds and
other timings that can be adjusted by the user sometimes you just want to factory restore the
chip to the beginning in case you forget that is active and what is altered.
r+a
S+2
To master reset the chip, activate (
) then hold down
for 6 seconds. After 6
seconds the light will fade in then fade out (pulse). Your chip is now reset.
Hide quick links:
Advertisement
Table of Contents
