System Menu - JVC GR-DVX400ED Instructions Manual

48
EN

System Menu

SYSTEM
Beep, melody and shutter sound
BEEP OFF
BEEP
MELODY
Tally lamp setting
TALLY OFF
ON
ID number setting (GR-DVX400 only)
This number is necessary when connecting the camcorder to a device such as a computer
ID NUMBER
using the J terminal (JLIP) or PC connector. The number range from 01 to 99. Factory
setting is 06.
Automatic demonstration mode
Demonstrates certain functions such as Program AE with special effects, etc., and can be used to confirm how
these functions operate. (
DEMO MODE OFF
ON
Even though not heard while shooting, shutter sound is recorded on the
tape.
The beep sounds when the power is turned on or off, and at the
beginning and end of recording. It also activates the shutter sound effect.
( pg. 27, 53)
Instead of a beep, a melody sounds when any operation is performed. It
also activates the shutter sound effect. (
The tally lamp remains off at all times.
The tally lamp comes on to signal the start of recording.
pg. 8)
Automatic demonstration will not take place.
Demonstrates certain functions such as Program AE with special effects,
etc., and can be used to confirm how these functions operate.
Demonstration starts in the following cases:
• When the Menu Screen is closed after "DEMO MODE" is turned "ON".
• With "DEMO MODE" set to "ON", if there is no operation for about
3 minutes after the Power Switch is set to "A" or "M".
Performing any operation during the demonstration stops the
demonstration temporarily. If no operation is performed for more than 3
minutes after that, the demonstration will resume.
NOTES:
If a cassette is in the camcorder, the demonstration cannot be turned on.
"DEMO MODE" remains "ON" even if the camcorder power is turned off.
If "DEMO MODE" remains "ON", some functions will not be available.
After viewing demo, set to "OFF".
RECORDING MENUS (cont.)
(
pg. 27, 53)
: Factory-preset)