JVC GR-DVX2 Instructions Manual page 62

62
EN
IN
0 0 : 2 5 ~ 0 2 : 0 5
41 W
H
2 0 7 : 1 8 ~ 0 8 : 3 1 – –
P
3 – – 0 3 : 3 3 ~ 0 5 : 5 3
4 0 9 : 3 0 ~ 1 3 : 1 5
5 1 5 : 5 5 ~ 1 6 : 2 0 – – – –
6 – – – – : – – ~
7
8
TIME CODE
TOTAL
Random Assemble Editing menu
RM-V711U
(provided)
FADE/WIPE
EFFECT
EDIT IN/OUT
CANCEL
8 REGISTER ADDITIONAL SCENES
Repeat steps 4 – 7 (
• To change previously registered points, press
CANCEL on the remote control. The
registered points disappear, one at a time,
from the most recently registered point.
9 PREPARE SOURCE TAPE
Rewind the tape in the camcorder to the
beginning of the scene you want to edit and
press the Pause button (6).
10 ENGAGE VCR'S RECORD-PAUSE
MODE
Point the remote control towards the VCR's
remote sensor and press VCR REC STBY, or
manually engage the VCR's Record-Pause
mode.
NOTES:
When the editing cable is connected to the Pause terminal during dubbing, make sure the remote control
is pointed at the recorder's sensor, and that the path between the two is unobstructed.
If, during Random Assemble Editing, you press any button on the camcorder, its Record-Standby mode is
automatically engaged.
Random Assemble Editing may not function properly when using a tape including several duplicated Time
Codes. ( pg. 21).
OUT MODE
– –
P
B/W
~
~
1 6 : 3 0
9 : 3 9
T W
PAUSE
R.A. EDIT ON/OFF
VCR REC STBY
pg. 61).
Power Dial
EDIT button
11 START EDITING
Press the EDIT button on the Docking Station.
Editing proceeds as programmed, right through
to the end of the last registered scene.
•When dubbing is complete, the camcorder
enters the Pause mode, and the recorder
enters its Record-Standby mode.
•If you don't register an Edit-Out point, the
tape will be dubbed all the way to the end
automatically.
12 STOP EDITING
Engage the Stop modes for the camcorder and
the recorder.
To make the R.A. Edit counter display disap-
pear, press R.A. EDIT ON/OFF on the remote
control.
EDITING
(Cont.)
Remote Sensor
REW button
STOP button
PAUSE button