JVC GR-DVX2 Instructions Manual page 57

3
AC Power Adapter/Charger
To DC
input jack
DC cord
Core filter
To VIDEO output jack
1 CONNECT DOCKING STATION TO
TV OR VCR
Connect as shown in the illustration
( pg. 56, 57).
If Using A VCR . . . go to step 2.
If not . . . go to step 3.
2
CONNECT VCR OUTPUT TO TV
INPUT
Refer to your VCR's instruction manual.
3 TURN ON POWER
4
SELECT TV'S VIDEO MODE
Set the TV to the channel or mode appropriate
for video playback.
Using the remote control unit with the camcorder attached to the Docking Station
While the camcorder is attached to the Docking Station, the camcorder's remote sensor does not function.
Point the remote control at the sensor located on the Docking Station.
To DC
output jack
Core filter
To S-VIDEO
output jack
To AUDIO input jacks (L/R)
To AUDIO
output jacks (L/R)
Red
White
Core filter
Yellow
1 2
, or
Remote sensor
S-VIDEO cable (provided)
To S-VIDEO input jack
Red
White
Yellow
To VIDEO
VIDEO/
input jack
AUDIO cable
(provided)
(connect when the S-VIDEO cable is not used)
NOTES:
When using the provided VIDEO/AUDIO cable
(Docking Station to TV or VCR), DC cord, S-
3
VIDEO cable or editing cable, make sure you
connect the end of the cable with the core filter to
the Docking Station. The core filter improves
performance of equipment.
If TV/VCR is equipped with only one audio
connector, use a conversion plug (commercially
available).
Set the VIDEO OUT select switch of the cable
adapter as required:
Y/C: When connecting to a TV or VCR which
accepts Y/C signals and uses an S-VIDEO cable.
CVBS: When connecting to a TV or VCR which
does not accept Y/C signals and uses an audio/
video cable.
To turn off the speaker's sound,
Connection to a TV or VCR
equipped with an S-VIDEO
IN and/or A/V input (RCA
type) connectors
To
TV or VCR
VCR
pg. 49.
57
EN