JVC GR-DVX Instructions Manual page 63

Power Dial
4 SET EDIT-IN POINT
At the beginning of the scene, press EDIT IN/
OUT on the remote control. The Edit-In
position appears on the Random Assemble
Editing Menu.
5 SET EDIT-OUT POINT
At the end of the scene, press EDIT IN/OUT.
The Edit-Out position appears on the Random
Assemble Editing Menu.
6
USE FADE WIPE ON SCENE
TRANSITION (IF NECESSARY)
Press FADE/WIPE.
•Cycle through the effects by pressing
repeatedly, and stop when the one you want
is displayed.
•If you select a Fade/Wipe effect for an
Edit-Out point, the effect is automatically
applied to the following Edit-In point.
•You can't use a Picture Wipe/Dissolve at the
end of the last scene.
•When you use Fade/Wipe effects, that time is
included in the total time (this does not apply
to Picture Wipe/Dissolve).
7
USE P.AE/EFFECT (IF NECESSARY)
Press EFFECT.
•Cycle through the effects by pressing
repeatedly, and stop when the one you want
is displayed.
•You can use Classic Film, Monotone, Sepia,
Strobe or Video Echo effects.
•If you're not using Fade/Wipe or P.AE/Effects,
repeat steps 4 and 5 only.
Remote sensor
RM-V711U
(provided)
T W
FADE/WIPE
EFFECT
EDIT IN/OUT
1 – – – – : – – ~
2
3
4
5
6
7
8
TIME CODE
PLAY
R.A.EDIT ON/OFF
NOTES:
When the source tape has more than 2 identical
time codes ( pg. 23), the camcorder may not
find the Edit-In point you chose and a malfunc-
tion may occur.
When choosing a scene, set Edit-In and Edit-Out
points so there's a relatively large difference
between them.
If the search time for an in-point exceeds 5
minutes, the recording deck's Record-Standby
mode will be cancelled and editing will not take
place.
If there are blank portions before or after the
Edit-In and Edit-Out points, a blue-backed screen
may be included in the edited version.
Since time codes register time only as accurately
as seconds, the time code total time may not
match the total program time exactly.
Turning off the camcorder's power erases all
registered Edit-In and Edit-Out points.
If you use Sepia or Monotone P.AE/Effects, you
can't use the Dissolve or Black & White Fader. In
this case the Dissolve or Black & White indicator
begins blinking. Once the next Edit-In point is
registered, the effect is turned off. To combine
these effects, use Sepia or Monotone during
recording, then use Dissolve or Black & White
Fader during Random Assemble Editing.
CONTINUED ON NEXT PAGE
EN
Program
IN OUT MODE
~
~
~
~
~
~
~
– – : – –
TOTAL 0 0 : 0 0
Random Assemble
Editing Menu
63