Circuit Breaker Placard; Post Installation Configuration And Checkout - Garmin GTX327 Installation Manual

1. Non-Garmin part numbers shown are not maintained by Garmin and consequently are subject
to change without notice.
2. Extracting the #16, #18 and #20 contact requires that the expanded wire barrel be cut off from
the contact. It may also be necessary to push the pin out from the face of the connector when
using an extractor due to the absence of the wire. A new contact must be used when
reassembling the connector.
3.3

Circuit Breaker Placard

Install a Circuit Breaker Placard labeled Transponder or Transponder 1, Transponder 2 as appropriate as
indicated in AC 43.13–2A, paragraph 27c(4).
3.4

Post Installation Configuration and Checkout

After the installation is complete, refer to Section 5 for system configuration.
Verify proper operation of the transponder by testing in accordance with Appendix F to 14 CFR Part 43 –
ATC Transponder Tests and Inspections.
Page 3-2
Revision K
NOTES
GTX 327 Installation Manual
190-00187-02