Windshield Wipers - GMC 2001 C3 Owner's Manual

Headlamp High/Low-Beam Changer
To change the headlamps from low to high beam or high
to low beam, pull the multifunction lever all the way
toward you. Then release it.
Flash-to-Pass Feature
This feature allows you to use your high
headlamps to signal a driver in front of you that you
want to pass. It works even if your headlamps are off.
To use it, pull the turn signal lever toward you, but not
so far that you hear it click.
2-32
When the high beams
are on, this light on the
instrument panel cluster
also will be on.
-
beam
If your headlamps are off or on low beam, your
-
high beam headlamps will turn on. They'll stay on as
long as you hold the lever toward you. The high
indicator on the instrument panel will come on. Release
-
the lever to turn the high

Windshield Wipers

You control the windshield wipers by turning the band
with the wiper symbol on it.
For a single wiping cycle, turn the band to MIST. Hold
it there until the wipers start, then let go. The wipers will
stop after one wipe. If you want more wipes, hold the
band on MIST longer.
You can set the wiper speed for a long or short delay
between wipes. This can be very useful in light rain
or snow. Turn the band to choose the delay time.
The closer to LO, the shorter the delay.
-
beam
beam headlamps off.