3.2.7 Installation of 4-shelf System (Side-by-side Type)
3.2.7 Installation of 4-shelf System (Side-by-side Type)
When vertical space is limited, it is possible to install shelves side-by-side. Installing the system using base
stands (supplied with an optional Mounting Kit) makes it easy to reinstall shelves in a different place.
Construction of 4-shelf System (Side-by-side Type)
Wall Bracket
(Left)
Expansion Shelf 1
Metal Bracket
Basic Shelf
Metal Bracket
Support Bracket
Base Stand
WARNING
Be careful not to drop any components. Dropping components may damage them or cause an
injury.
CAUTION
•
Do not block the openings of the shelf. Allow space of at least 10 cm (4 in) at the sides of the shelf,
and 20 cm (8 in) above the top-mounted shelf.
•
Make sure that the surface behind the shelf is flat and free of obstacles, so that the openings on the
back of the shelf will not be blocked.
•
Make sure that the surface behind the shelf is not made of wood.
Note
•
Make sure to remove the front cover from each shelf before installing the shelves (refer
to "3.2.3 Opening/Closing the Front Cover").
•
Do not install any optional service cards or a PSU in the shelves before installation.
•
Make sure to install the shelves where the Bus Cable (supplied with a BUS-M card or BUS-ME card)
can reach the shelves.
90
Installation Manual
Wall Bracket
(Right)
Expansion Shelf 3
Metal Bracket
Expansion Shelf 2
Metal Bracket
Support Bracket
Base Stand
Document Version 2009-12