Page 1
LCD MONITOR LMD-1420 LMD-1410 SERVICE MANUAL 1st Edition...
Page 2
Ce manual est destiné uniquement aux personnes compétentes en charge de l’entretien. Afin de réduire les risques de décharge électrique, d’incendie ou de blessure n’effectuer que les réparations indiquées dans le mode d’emploi à moins d’être qualifié pour en effectuer d’autres. Pour toute réparation faire appel à une personne compétente uniquement. LMD-1420/1410...
Section 1 Service Overview 1-1. Appearance Figure 1-2. Board Location GA board X board (LMD-1420 only) Q board BA board S board Inverter board H board J board LMD-1420/1410...
2 Harness cover 3 Three harnesses 9 Two screws (PSW3 x 12) !/ AC holder 4 Screw 7 Two screws (PSW4 x 8) (PWH3 x 6) 5 Harness 8 Q board 6 Two screws (PWH3 x 6) !- AC inlet Cushion LMD-1420/1410...
. Remove the Q board. (Refer to Section 1-3-2.) 2 Frame 1 Five screws (PWH3 x 6) 6 Ten harnesses 4 Four screws (PWH3 x 6) 7 Five screws (PWH3 x 6) 3 Five harnesses 8 BA board 5 Inverter board Cushion LMD-1420/1410...
. Remove the rear cover. (Refer to Section 1-3-1.) . Remove the Q board. (Refer to Section 1-3-2.) 1 Two screws (PWH M3 x 8) 3 J board 2 Harness 6 AC cover 5 Three hooks 4 AC button Cushion LMD-1420/1410...
3 Four screws (PWH M3 x 8) (PWH M3 x 8) 5 Main frame 8 LCD panel !/ Two cushions 9 Two cushions !- Protection plate 7 Two screws (PWH3 x 6) 6 Two screws (PWH3 x 6) Cushion LMD-1420/1410...
1-3-8. H Board/X Board (X Board: LMD-1420 only) . Remove the rear cover. (Refer to Section 1-3-1.) . Remove the Q board. (Refer to Section 1-3-2.) . Remove the GA board. (Refer to Section 1-3-3.) . Remove the inverter board and BA board. (Refer to Section 1-3-4.) .
VM0089 COX-02/VM0310B VM0303B Cord type H05VV-F CEE (13) 53rd (O, C) Rated Voltage & Current 10 A/125 V 10 A/250 V 10 A/250 V Safety approval UL/CSA 1) Use an appropriate rating plug which is applied to local regulations. LMD-1420/1410...
Down ↓ key. Press the “ENTER” key to enter the “COLOR TEMP” layer. 7. Move the cursor to “C-TEMP SAVE” using the Down ↓ key and press the “ENTER” key. Select “LOW” using the Up ↑ key and press the “ENTER” key. LMD-1420/1410...
Is the backlight lit when another BA board Replace the BA board. is installed? Is the backlight Replace the GA board. lit when another GA board is installed? Replace the LCD panel. LMD-1420/1410...
Is the symptom improved by the external Replace the BA board. operation of PARALLEL REMOTE terminal? For the external operation of PARALLEL REMOTE terminal, refer to the Operating Instructions. Replace the H board. LMD-1420/1410...
Is the symptom improved when another Replace the BA board. BA board is installed? Replace the LCD panel. 3-5. TALLY lamp is not lit (LMD-1420 only) TALLY lamp is not lit. Are harness and Connect the harness and flexible flat cable connected flexible flat cable correctly.
Is there any fan that Replace the BA board. operates normally? Replace the abnormal fan. Is the symptom improved? No problem. Is the symptom improved when another Replace the BA board. BA board is installed? Replace the GA board. LMD-1420/1410...
Therefore, specified parts should be used in the case of replacement. 2. Standardization of Parts Some repair parts supplied by Sony differ from those used for the unit. These are because of parts common- ality and improvement. Parts list has the present standardized repair parts.
Overall Block Part No. SP Description X-2050-919-1 s BEZEL ASSY (for LMD-1410) X-2050-920-1 s BEZEL ASSY (for LMD-1420) X-2055-900-1 s STAND ASSY 1-787-341-11 s FAN , DC (40 SQUARE) 1-787-342-11 s FAN, DC (35 SQUARE) 1-789-212-11 s MOUNTED CIRCUIT BOARD, X...
4-4. Packing Materials & Supplied 4-3. Electrical Parts List Accessories *1:[LMD-1410] ---------------------------------------- *2:[LMD-1420] PACKING MATERIALS & SUPPLIED ACCESSORIES ---------------------------------------- Ref. No. Ref. No. or Q'ty Part No. SP Description or Q'ty Part No. SP Description *2 1-789-212-11 s MOUNTED CIRCUIT BOARD, X...
Page 23
SYNC LDVS RECEIVER LVDS PANEL NTSC 3-DIMENSION ADG779 DIGITAL COM FILTER TALLY_G TALLY_R TALLY (FOR LMD-1420) 5-INPUT 2-OUTPUT AUDIO/VIDEO SW C / VCC KEY PAD SP232 RGB IN RGB OUT PARALLEL 8PIN SYNC SYNC LINE A IN LINE A OUT...
Page 27
2 V AC range are suitable. (See Fig. A) To Exposed Metal Parts on Set 0.15 µ F 1.5 k Z voltmeter (0.75V) Earth Ground Fig A. Using an AC voltmeter to check AC leakage. LMD-1420/1410...