HP ProCurve 2510G Series Manual page 101

TACACS+ Authentication
Configuring TACACS+ on the Switch
Encryption Options in the Switch
When configured, the encryption key causes the switch to encrypt the
TACACS+ packets it sends to the server. When left at "null", the TACACS+
packets are sent in clear text. The encryption key (or just "key") you configure
in the switch must be identical to the encryption key configured in the
corresponding TACACS+ server. If the key is the same for all TACACS+
servers the switch will use for authentication, then configure a global key in
the switch. If the key is different for one or more of these servers, use "server-
specific" keys in the switch. (If you configure both a global key and one or
more per-server keys, the per-server keys will override the global key for the
specified servers.)
For example, you would use the next command to configure a global encryp-
tion key in the switch to match a key entered as in two target
north40campus
TACACS+ servers. (That is, both servers use the same key for your switch.)
Note that you do not need the server IP addresses to configure a global key in
the switch:
ProCurve(config)# tacacs-server key north40campus
Suppose that you subsequently add a third TACACS+ server (with an IP
address of 10.28.227.87) that has south10campus for an encryption key.
Because this key is different than the one used for the two servers in the
previous example, you will need to assign a server-specific key in the switch
that applies only to the designated server:
ProCurve(config)# tacacs-server host 10.28.227.87 key
south10campus
With both of the above keys configured in the switch, the south10campus key
overrides the north40campus key only when the switch tries to access the
TACACS+ server having the 10.28.227.87 address.
4-27