Table of Contents
Advertisement
Standard settings
To ensure that some of the camera functions are not
set to unusual values a standard file has been defined
in the factory which contains the normal values for
most functions. The table in the appendix lists the
values that are set when the standard file is recalled.
Use the selection switches at the rear and the
viewfinder display to recall the standard values from
the Files menu for the various functions. The standard
values only take effect when the camera goes Off-air.
The MCP can select the standard file as a factory or
customer standard file.
Shooting
Note
Operator's Manual LDK 20(S) - Studio Camera
Colour Bar
The Operate menu contains a selection for switching
on the colour bar test signal. The colour bar is a
standard test signal which is used to set up and check
the camera before use.
When the colour bar is selected the following functions
are temporarily set to the values listed below:
Black stretch
White limiter
Zebra
Safe area (VF)
Cadre (VF)
Filter wheel
:
Off
:
Off
:
Off
:
Off
:
Off
:
Cap
5-3
Advertisement
Table of Contents
