mabe RMS1540Z Use And Care Manual page 24

cleaning the tray
1. Firstly, open the front door where
you see a small lip on the right-hand
side. Pull the door towards you until
completely open.
2. Then, to remove the ice-tray from its
fitting, take it by the right-hand side
and at the same time, pull it down and
towards you. Finally, pull it out by the
centre, keeping it horizontal.
3. To replace the ice-tray in the
Ice Factory, align the short sides with
the lateral fittings and push it until it's
completely inserted.
4. Afterwards, push the tray by the
right-hand side until you hear a click,
which will ensure the tray securely in
place while working.
5. Close the lid of the
Factory. Your device will be ready for
use once again.
important:
Use tepid water to remove residual ice which will form with
regular use of the Smart Fill Ice Factory. This residue could form on the lid
you use to fill the water cylinder, the cylinder valve, and the ice-box, thus
affecting the working of different parts of the system.
Don't use ice-picks, forks, or knives to remove the residual ice as to do so
could damage the Smart Fill Ice Factory.
Smart Fill
Smart Fill Ice
77