JVC GR-AXM10 Instructions Manual page 30

30
EN
MENU
FAR
PROGRAM AE select dial
Rec Time Indicator
LCD monitor or viewfinder
GAIN UP
TELE MACRO
INTERVAL TIMER
REC TIME
JLIP ID NO.
SET CHARACTER
DATE/TIME
END :MENU KEY
1S 1/2S
5MIN 1MIN
NEAR
Tally lamp
Interval Timer Indicator
1MIN
1/2S
S.LX
OFF
OFF
OFF
07
1/4S OFF
30S 15S OFF
RECORDING
Self-Timer
You can set the delay between pressing the Recording
Start/Stop button and the actual start of recording. If you
secure the camcorder, you (or whomever is operating the
camcorder) can enter the scene before recording starts.
NOTE:
Make sure the camcorder is in the Record-Standby mode
before performing the following steps.
ACCESS MENU SCREEN
1
Turn the PROGRAM AE select dial to any position
except AUTO LOCK, then press MENU.
SET INTERVAL TIME
2
Press – or + to move the highlight bar down to
"INTERVAL TIMER", then press FAR or NEAR to
cycle through the choices. Stop when the desired
time appears. Choose from "15S", "30S", "1MIN",
"5MIN", or select to turn the function "OFF".
CLOSE MENU
3
Press MENU.
START DELAYED RECORDING
4
Press the Recording Start/Stop button. The tally lamp
begins blinking, and the blinking frequency
increases about 5 seconds before recording is to
start. Once recording begins, the lamp stops
blinking but stays lit.
To Release Self-Timer . . .
..... while the tally lamp is blinking, press the Recording
Start/Stop button to stop the blinking, then set
"INTERVAL TIMER" to "OFF".
Advanced Features (cont.)