General Information - MULTIQUIP Mikasa MTX-80 Operation And Parts Manual

Definition of Tamping Rammer
The Mikasa MTX-80/MTX-90 tamping rammer is a powerful
compacting tool capable of applying a tremendous force in
consecutive impacts to a soil surface. Its applications include
soil compacting for road, embankments and reservoirs as
well as backfilling for gas pipelines, water pipelines and cable
installation work.
The impact force of the MTX-80/MTX-90 levels and uniformly
compacts voids between soil particles to increase dry density.
Circular motion is converted to create impact force. The MTX-
80/MTX-90 tamping rammer develops a powerful compacting
force at the foot of the rammer. To maintain optimum
performance, proper operation and service are essential.
Construction of Tamping Rammer
The Mikasa MTX-80/MTX-90 is equipped with an air cooled,
four- cycle gasoline engine. Transmission of the power takes
place by increasing the engine speed to engage the
centrifugal clutch.
Rammer Gearbox and Spring Cylinder
The Mikasa MTX-80/MTX-90 uses an oil bath lubrication
system. Always check the oil level through the oil level sight
glass at the rear of the tamper foot.
Controls
Before starting the MTX-80/MTX-90 Tamping Rammer identify
and understand the function of the controls.
PAGE 10 — MTX-80/MTX-90 — OPERATION AND PARTS MANUAL — REV. #3 (01/04/08)
MTX-80/MTX-90 — GENERAL INFORMATION
CAUTION CAUTION
CAUTION CAUTION CAUTION
1. Make sure that there is no damage on the bolts.
2. Make sure that there is no crack or breakage on handle.
3. Make sure that there is no fissure on the surface. If there
is any abnormality or damage, replace with new one.
For operation:
This handle is to be used to lift up the shoe part of the machine
with the body laid down on the ground or truck bed.
1. Use proper lifting techniques to avoid back injury. This
handle is for manual lifting only.
2. Do not use this handle as a rammer lift point. Use the
lifting point on the top of the machine.
3. Do not move the rammer with the lifting handle and the
front rollers more than 16 feet (5 meters).
Handle Operation
Before starting operation check the lifting
handle to: