Installing The Installation Software - Hughes DW6000 Installation Manual

Installing the
installation software
The installation software is on a CD and it must be installed on
the installer laptop. The software will enable installers to register
DW6000 customers. A DW3000 or DW4000 receive modem
(IRU) is required to install the software on the installer laptop.
Do not confuse the installation software with the software that is
downloaded to the DW6000 via satellite during registration. The
DW6000 installation software enables you to register customers
and configure the DW6000 for operation. The software that
actually operates the DW6000 is downloaded during registration.
Do not connect the USB cable to the DW4000 until prompted to
do so. You may use the cable that came with the unit, or a
different cable if you need a longer one.
Note: You only need to perform the instructions in this section
one time to set up your laptop computer with the installation
software.
Note: You may see a pop-up window stating the hardware driver
for the IRU has not passed Windows logo testing. Click
Anyway
to continue. Hughes has tested the installer software and
confirmed it will function on the operating systems identified in
Installation PC requirements on page 83.
Follow these steps to install the software on the installer laptop:
1. Load the installer software CD into your laptop computer.
The installation wizard should appear. If it does not, select
Start → Run ,
browse to the CD drive, select it, and select
setup.exe.
2. Select Install Software. A
Figure 67: Installation screen
Appendix A • Installing the DW6000 using dial-up commissioning
Continue
screen appears.
Setup
1033295-0001 Revision A
87