Viewfinder Adjustment; Tape Length/Recording Mode; Setting; Loading/Unloading A Cassette - JVC GR-AX210 Instructions Manual

SP-LP recording mode and
T30•45 tape length select button
Set POWER to "CAMERA".
Tape length and recording
mode indicator
T30 SP
T30 SP
T45 LP
Erase Protection Gear
GR-AX210EK-2

Viewfinder Adjustment

1
2
3
Tape Length/Recording Mode Setting
1
2
NOTE:
T30 LP
The tape remaining time indicator does not work with
tapes other than EC30 and EC45. (See Basic Recording
T45 SP
on pg. 12 for "tape remaining time indicator".)

Loading/Unloading A Cassette

1
2
3
NOTES:
A cassette holder can't be opened unless a power
supply is attached.
Turn to take up
Make sure that the tape is not slack when loading the
slack.
cassette. If there is any slack, turn the gear on the
cassette in the direction of the arrow to take up the
slack.
Make sure the Erase Protection tab is present. If not,
cover the hole with adhesive tape. (Some cassettes
have sliding tabs – in this case, check the tab's position.)
9
POSITION VIEWFINDER
Adjust the viewfinder manually for best viewability
(see illustration at left).
SELECT MODE
Set the power switch to CAMERA.
ADJUST DIOPTER
Turn the diopter adjustment control until the
indications in the viewfinder are clearly focused.
SET TAPE LENGTH
Set the tape length button according to the length of
the tape used. T30 = 30 minutes of recording time
and T45 = 45 minutes (in SP).
SET RECORDING MODE
Set depending on your preference. "SP" (Standard
Play) provides higher picture and sound quality and
is better for dubbing, while "LP" (Long Play) is
more economical, recording at 1/2 the speed of SP.
OPEN CASSETTE HOLDER
Slide EJECT until holder opens. Do not use force to
open.
INSERT/REMOVE CASSETTE
Make sure label is facing outward.
CLOSE CASSETTE HOLDER
Press PUSH and make sure the holder is closed and
locked.
96.10.8, 1:25 PM
9