Behringer Shark DSP110 User Manual page 10

Fig 1.3: Rear panel control elements and connectors of the DSP110
14 This is the SHARK’s balanced XLR output.
15 This is the SHARK’s balanced XLR input.
16 The MIC GAIN control adjust the input signal gain, when the INPUT LEVEL
switch has been pressed (position: MIC). To adjust microphone levels you
can use the CLIP LEVEL indicator, by setting the CLIP LEVEL control to mid-
travel position. Please make sure that the CLIP LED will not light up.
17 Use the POWER SUPPLY CONNECTOR to hook up the SHARK’s external
power supply.
18 This is the SHARK’s balanced JACK output, which carries the same signal as
the XLR output.
19 The OUTPUT LEVEL switch controls the reference level provided by the outputs
of the DSP110. Possible values are: +4 dBu or microphone level.
10
SHARK DSP110
1. INTRODUCTION