Displaying The Currently Used Cryptographic Key Number - Ericsson EDACS PRISM HP Operator's Manual

2. Plug the modular connector of the Keyloader cable
into the Keyloader modular jack.
3. Connect the Keyloader cable to the UDC on the
radio.
4. Press the PWR button on the Keyloader and wait for
the Keyloader to display "MASTER MODE".
5. Press the TRN button on the Keyloader. If neces-
sary, select a different cryptographic key to be trans-
ferred into the radio.
6. Turn the radio on. The top line on the radio display
<
will read "KEY LOAD" and the second line will read
"BANK = N" where N=keybank number. Press the
or
will indicate that the keyloader is connected.
7. Press the EXE button on the Keyloader to transfer
the key. The Keyloader will display "GOOD 1.x
TRANSFER" where "x" is the selected cryptographic
key number.
8. Disconnect the cable from the radio UDC. The radio
will change to the selected group or channel as
indicated in the display.
Displaying The Currently Used Cryptographic Key
Number
To display the cryptographic key currently in use for
either the system encryption key (for special call such as
74
>
button to select the keybank. A beep