Rewind The Tape - JVC 1001MKV*UN*SN Instructions Manual

!
@
Y
T
l
A
SELECT SCENES
4) Point the remote control at the camcorder's
remote sensor. Press PLAY S
ON/OFF on the remote control. The R.A. Edit
counter display appears. Y
5) Press REW or FF
of the scene you want, then press IN/OUT
register that point. The data appears under "IN"
on the display. Y
6) Press REW or FF
scene and press IN/OUT
• The data appears under "OUT" on the display.
• The total time of the registered scene(s) is
displayed at the bottom of the screen.
7) Repeat steps 5 and 6 for each additional scene
(as many as 8).
8) To make corrections, press CANCEL
steps 5 and 6 to erase the most recently
registered point.
• There must be at least one second between an
in-point and its corresponding out-point.
• To ensure correct operation, there should be at
least 15 seconds between an out-point and the
next in-point.
• Blank portions of a tape cannot be registered as
in-points or out-points.
• If it takes more than 5 minutes to search for an in-
point, the VCR's Record-Pause mode is cancelled
and editing does not take place.
Remote sensor
s
S
RM-V700U
(optional)
T
, then press
a
to locate the beginning
a
l
to locate the end of the
to register it.
;
during
• Pressing ON/OFF
from memory.
• Leave a small margin for error around each in-
point to ensure the scene is recorded in its
entirety.
• Turning off the camcorder's power erases all
registered in- and out-points.
AUTOMATIC EDITING TO VCR
9) Rewind the tape in the camcorder to the
beginning of the scene you want to edit and
press PAUSE
10) Point the remote control towards the VCR's
infrared sensor and press VCR REC STBY
or manually engage the VCR's Record-Pause
mode.
11) Press the Recording Start/Stop Button on the
a
camcorder to begin Automatic Editing, and the
previously selected scenes are copied to the
;
VCR in the specified order.
While editing, the R.A. Edit counter of the
scene which is being copied is shown with a
blinking highlight.
• Pressing START/STOP
does not start editing.
12) When all selected scenes have been copied,
the camcorder and VCR enter the Still or
Pause mode. Press STOP
the R.A. Edit counter display disappear, press
ON/OFF
• When finished editing, be sure to disconnect the
l
editing cable and the A/V cable.
to
• If you performed step
CONNECTIONS"), keep the remote control
pointed at the VCR during editing.
• The on-screen display only appears while the
camcorder searches for each scene.
• There may be noise at in- or out-points on the
edited tape with certain VCRs.registered in- and
out-points.
28
S
clears all in- and out-points
s
.
P
on the remote control
$
S
.
1 on page 27 ("MAKE
A
,
U
and . To make