Physical Interface - TRENDnet TEG-082WS User Manual

TRENDnet User's Guide
System Log Settings
Time Stamp: Enable/Disable the time stamp on log entry. Default:
Enabled.
Message Enter the message buffer size. Default: 50 entries,
Buffered Size: Range: 1-200.
Syslog Status: Enable/ Disable to store the logs on remote log server.
Default: Enabled.
Syslog Server IP: Enter the IPv4 or IPv6 address of the external syslog
server to send logging.
Facility: Click the drop-down list and which facility to store the
logging. (Options: local0 – local7)
Note: You can define the facility to store logging on your
external syslog server. This helps to ensure you have
separate logging sections for different devices.
Logging Level: Click the drop-down list to select what level of event
messages that will be logged.
0. Emergency: The system is unusable.
1. Alert: Action must be taken immediately.
2. Critical: Critical conditions are displayed.
3. Error: Error conditions are displayed.
4. Warning: Warning conditions are displayed.
5. Notice: Normal but significant conditions are
displayed.
6. Informational: Informational messages are
displayed.
7. Debug: Debug-level messages are displayed.
Click Apply to apply the change to the switch
Go Save Settings to Flash section to save the change on the flash to make
sure the change is permanent.
© Copyright 2014 TRENDnet. All Rights Reserved.

Physical Interface

This section allows you to configure the physical port parameters such as
speed, duplex, flow control, and jumbo frames. This section also reports the
current link status of each port and negotiated speed/duplex. Additionally
you will be able to set your BPDU ports for Spanning Tree Configuration and
EAP ports for 802.1X port-based authentication configuration.
TEG-082WS
22