Precor C932 Service Manual page 9

Procedure 2.2
The information display will access the following data;
• Odometer
• Hour meter
• Software version
• Error log
Procedure
1. Plug the power cord into the wall outlet, then turn on the treadmill with the circuit breaker.
2. Press the keys RESET,6,5, sequentially.
3. For C932 and C932i treadmills, skip to step 19. For C934 and C936i treadmills, continue
with step 4.
4. The display will momentarily read, ODOMETER.
5. The treadmill's odometer will be displayed as 1234567.
Note: The odometer data is stored in non-volatile memory on the upper PCA. If the upper PCA
is replaced the odometer data will be lost.
6. Press the ENTER key to proceed to the hour meter display.'
7. The display will momentarily read, HOUR METER.
8. The operating time of the unit will be displayed as 12345. The operating time is defined as
total amount of time that the unit has operated in program modes with the drive motor
running. The hour meter is also used to provide the "time stamp" for the error code log.
9. Press the ENTER key to proceed to the software version display.
10. The display will momentarily read, SW VERSION.
11. The software versions of the upper and lower PCA's will be displayed as; Ver X.XX.
12. Press the ENTER key to proceed to the error log.
13. The error log will store up to 10 error conditions. The errors are logged with the most recent
error in position one. When a new error condition occurs, each existing error is pushed down
one position in log. If there was an error in position 10 when a new error was logged, the
error that was in position 10 will be lost.
14. The display will momentarily read, ERROR LOG.
- Accessing the Information Display Program
C932, C932i, C934, C936i Treadmill
Page 9