Advertisement
USING THE AMPLIFIER AS A
PORTABLE PUBLIC
ADDRESS (PA) SYSTEM
You can use the amplifier as a portable PA
system with a directional dynamic microphone
1
(not supplied) with a
/
-inch plug. Simply in-
4
sert the microphone's plug into the
jack.
CARE
Keep the amplifier dry; if it gets wet, wipe it dry
immediately. Use and store the amplifier only
in normal temperature environments. Handle
the amplifier carefully; do not drop it. Keep the
amplifier away from dust and dirt, and wipe it
with a damp cloth occasionally to keep it look-
ing new.
Modifying or tampering with the amplifier's in-
ternal components can cause a malfunction
and might invalidate its warranty. If your am-
plifier is not performing as it should, take it to
your local RadioShack store for assistance.
Caution: You might permanently damage
your speaker by cleaning it with a vacuum
cleaner. Use a feather duster or a soft loose
cloth instead.
SPECIFICATIONS
Output Power ................................. 10 Watts, RMS
Input Sensitivity ............................................ 50 mV
INPUT
Controls ................. Treble 10 kHz, ±12 dB Variable
Power Requirement ...................... 120 VAC, 60 Hz
Speaker ................................................. 8-inch, 4 Ω
Dimensions (HWD) ........... 13 × 12
Weight ......................................................... 5.2 kgs
Specifications are typical; individual units
might vary. Specifications are subject to
change and improvement without notice.
3
(4 Ohms, THD 10%)
(1 kHz; Max. Volume)
Treble, Mid, Bass set to 5
Distortion Off
Mid 2 kHz, ±12 dB Variable
Bass 40 Hz, ±15 dB Variable
× 5
1
1
/
/
Inches
2
4
(33.5 × 31.5 × 13.5 cm)
(11.5 lbs)
Advertisement
