RIDGID NaviTrack Operator's Manual page 11

NaviTrack™ Line Transmitter
High Voltage Indicator
Whenever the line transmitter encounters voltage higher
than 30V (RMS) it will flash a red LED at the bottom left
of the keypad.
Chart 1 Troubleshooting
PROBLEM
Receiver will not pick
Check that the correct frequency is selected.
up the line transmitter's
Make sure that the leads to line and to the ground are attached securely.
signal.
Circuit connection has too much resistance impeding current flow.
Check orientation of batteries.
Check that the batteries are charged.
Unit will not turn on.
Check to see that the battery contacts are OK.
Unit may have blown a fuse.
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176
PROBABLE FAULT LOCATION
FAX 781.665.0780 - TestEquipmentDepot.com
9