RIDGID NaviTrack Quick Start Manual

Quick Start Guide – NaviTrack Sonde & Line Locator
Identification & Setup
Display Screen
Keypad
Handle
Speaker
Headphone
Jack (under
cover)
Keypad & Screen Reference
Up Key
Menu Navigation/Signal
Capture/1000 Set (3 sec. press)
Sound Key
) )
) )
) )
Mode Key
NOTE: Cycle power ON/OFF to reset 1000 Level and Zero Set to default levels.
Setting Information Level
The NaviTrack has three levels of information to choose from. Entering this
menu will allow the user to choose the amount of information displayed on
the screen.
Main Menu
Press Menu Key once to
open the Main Menu.
Selected Menu Item
Use Up or Down keys to
choose menu item
Info Level Menu
Use Select Key to select
highlighted item.
Selected Menu Item
Use Up or Down keys to choose
desired information level. Then use
Select Key to select highlighted item;
NaviTrack returns to the Active View
Setting Sound Level
Open Sound Menu
Choose menu item
Select highlighted
item
TM
Select Key
Note: Icons used on the
label are also used on the
View Toggle/ Menu
LCD display, and have the
Selection
same meanings
Menu Key
Power ON/OFF Key
Down Key
Menu Navigation/Depth Average
& Hold/Zero Set (3 sec. press)
Sound Level Menu
Battery
Compartment
Serial Number
Label
Icon list Label
Markers
Upper Antenna
Antenna Mast
Lower Antenna
Distance
Measure Point
Backlight Icon
Sonde Frequency
Sonde Level
Active Trace Frequency
Active Trace Level
Passive (AC) Trace Frequency
Passive (AC) Trace Level
Audio Level
Battery Level
Distance (Depth)
Distance Units
Selecting Operating Mode & Frequency
Press Mode Key once to
open the Mode Menu. Press
Mode Key again to open the
h i g h l i g h t e d m o d e ' s
Frequency Menu
Use Up or Down keys to
choose menu item
Use Select Key to select
highlighted item; NaviTrack
returns to the Active View
NOTE: If available frequencies do not match
your transmitting equipment, a new set of
frequencies may be loaded. See "Configuration
Menu" section of Operator's Manual for details.
Depth Average & Hold
Averages the depth reading over a four (4) second interval and holds the reading on the
display. Press once to take reading, press again to return to real time depth
display. Icon shown when depth held. Depth readings are available in feet and
inches (xx' xx"), decimal feet (xx.xx'), and meters (xx.xx m).
Icon shown when
depth averaged over the
pole.
Install four (4) C-cell batteries
Signal Capture – When activated
(Search View only)
Overhead Indicator
Mode Menu
Selected Mode and
Active Frequency
Sonde Mode
Line Trace Mode
Passive (AC)
Trace Mode
Frequency Menu
Selected Frequency
Operating Mode
See User Manual for details
2D Horizontal Field
Angle Indicator
Numeric Horizontal
Angle Indicator
Active View (Search
view shown in gray for
illustration purposes)
Auto Gain Step
Current Strength