Sundance Spas Burlington Owner's Manual page 25

10. Leave spa cover open during this step to allow
excessive chemical vapors to exit spa, protecting
plastic knobs and pillows on Burlington, Hartford
Hawthorne and Tacoma models from chemical attack.
If spa is indoors, open doors and windows for proper
ventilation. Turn on all spa jets pumps for one hour, open
all air controls. On Burlington, Hartford and Hawthorne
(Figure A) and Denali (Figure B) models, place the
Massage Selector or Diverter Jet in their center "combo"
position as shown (right). Note: You will need to press
the jets pump button(s) every 20 minutes since these
functions have an automatic 20 minute time-out
function that turns them off.
CAUTION: Never leave your spa unattended for any reason
!
while the cover is open and accessible to small children and
animals!
11. Turn off power to the spa at the circuit breaker, then drain spa as
outlined in Section 11.2 (page 31).
12. Refill spa with clean tap water from garden hose until water covers
all jets (DO NOT OVERFILL!)
CAUTION: Never fill with water from a water softener. If your
!
water is extremely "hard", it is preferable to fill half-way with
hard water and the rest of the way with softened water. Or,
you may fill entirely with hard water if you use a special water
additive available from your authorized Sundance dealer.
13. Consult your authorized Sundance dealer for chemical recommen-
dations, then add chemicals to spa water to achieve a constant
sanitizer reading within the levels recommended by the Association
of Pool And Spa Professionals/USA printed on the inside cover of
this manual.
14. Turn on all jet pumps when adding chemicals to ensure proper mix-
ing and leave your spa cover open until the sanitizer level falls below
4.0 ppm to protect plastic knobs and pillows from chemical attack.
Massage Selector
Figure A
Figure B
Set all air controls
to their full open
counterclockwise
position
Page 19