Replacing The Bean Hopper; Clearing A Clogged Grinder - Baratza Virtuoso Operation Manual

red tab on the burr with the rectangular cutout on the black adjustment ring.
Wiggle and push down firmly on the ring burr to ensure that it seats properly.
After replacing the burr, replace the silicone seal by lining up the two slots in
the silicone seal with the small tabs on the top of the ring burr and slide the
seal onto the ring burr.
Replacing the Bean
Hopper
To replace the bean hopper, line up
the two small tabs on the base of the
hopper with their respective slots in
the top of the grinder housing and
insert the hopper into the grinder.
Once the hopper is in place, rotate it
clockwise.

Clearing a Clogged Grinder

If your grinder is not dispensing coffee normally, it could be clogged with coffee
powder. This can happen if the grounds bin or portafilter are allowed to overfill
and ground coffee gets backed up into the grounds chute and grinding chamber.
It can also happen with the buildup of coffee powder over time.
Go to the Troubleshooting section on Baratza.com for help unclogging your
grinder.
Virtuoso Manual
TM
15